3/2/2024 0 Comments Roger smithThe co-axial escapement was conceived by George Daniels in 1975. The escapement is a single wheel co-axial system developed by Roger Smith. The escapement of the Roger Smith Series 2. Lange learnt this craft from the English when he did his Journeyman years in England. The German school of watchmaking, a tradition started by Ferdiand Adolph Lange in 1845 also employs the three quarter plate for the same reasons. It gives great rigidity to the movement – this was a traditional feature used solely for the highest quality British work. A large three quarter plate adorns almost the entire case back, covering the ratchet wheel, click work and crown wheel. Designed from ground up, and made completely in-house, the movement is made using the traditional crafts prescribed by the Daniels Method. ![]() The movement is where Roger spends a considerable amount of time in. The hands are not flat, but 3 dimensional and gives an appearance of strength. The result is hands which are very legible, and have a strong look. The hands are sculpted from a sheet of material 0.5mm thick, and given a final hand polishing. This traditional method of construction is very time consuming as each part is hand cut, hand finished and hand attached, but it also means that the dial has an infinite lifespan, and the dial is a work of art from both an engineering perspective as well as an aesthetic one. The dial background is flame whitened prior to the fitting of the hand grained chapter rings. The lettering, numerals are also cut by hand. The base dial is hand g uilloché on a Rose and Straight line engine. ![]() And the contrast to the lacquered numerals and the flamed whitened dial. Note the thick hands, which make legibility very good. A wrist shot, shows off the dial and its magnificence.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |